Answer to Question 1
The moveable mold system has fewer molds than the rotary system and therefore less investment. The moveable mold system is less complicated mechanically and is therefore less costly to buy and to maintain. The moveable system need not be synchronized as precisely as the rotary system.
Answer to Question 2
Aluminum advantages:
Lower initial cost due to lower machining time Shorter delivery time
More even heat distribution
Shorter cycle from higher thermal conductivity Lighter weight
Easier to cast should that be the preferred fabrication method
Aluminum disadvantages:
Must be anodized to get hardness and anodizing may wear off
Long-term wear us high
Answer to Question 3
These extensions of the runners are placed at points where the runners change directions and are a means of capturing the cold, leading front of the resin. By capturing the cold end of the resin flow, some assurance is given that the resin will flow smoothly through the gate without plugging.
The Uranus System
Gastrointestinal system
Divisions of the nervous system.
Disorders of the Cardiovascular System Cont.
Heat Exchanger Block Diagram Feedback Control System
A comparison of normal versus petite colonies in the yeast Saccharomyces cerevisiae