Technician A says to install press-fit ball joints using a hammer on the ball joint housing to seat the ball joint in the control arm. Technician B says that a tool resembling a large C-clamp should be used to press ball joints in and out. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
Technician A says that a torque arm is designed to support the weight of the vehicle. Technician B says that a torque arm is designed to prevent rear axle wind up. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Structure of a generalized synovial joint.
Joint of the right hip
Some IAC units are purchased with the housing as shown. Carbon buildup in these passages can cause ...
Figure-8s on the toes mobilize joints of the foot.
Position sense of joint movement
Ethanol has the molecular formula C2H6O. Which ball and stick model shown above represents ...