Technician A says that the cam bearings should be installed using a driver and dead blow hammer. Technician B says that main bearings and rod bearings should be checked for proper oil clearance by measuring the crankshaft journals and inside diameter of bearings. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Question 2
Engine pre-oiling is recommended for which of these reasons?
A) Helps the rebuilt engine develop power
B) Fills the oil passages with oil prior to initial start-up
C) Both A and B
D) Neither A nor B
Nitrogen content of live and dead leaves
A typical beginning technician tool set that includes the basic tools to get started.
The oil pressure switch is connected to a warning lamp that alerts the driver of low oil pressure.
A dual turbocharger system installed on a small block Chevrolet V-8 engine.
Be sure that the clips are properly installed. Start the engine and check for proper operation.
Percussion hammer