Technician A says that the cam bearings should be installed using a driver and dead blow hammer. Technician B says that main bearings and rod bearings should be checked for proper oil clearance by measuring the crankshaft journals and inside diameter of bearings. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Question 2
Engine pre-oiling is recommended for which of these reasons?
A) Helps the rebuilt engine develop power
B) Fills the oil passages with oil prior to initial start-up
C) Both A and B
D) Neither A nor B
Combustion chamber volume is the volume above the piston with the piston at top dead center.
A typical ball-peen hammer.
A whistle stop used to find top dead center. Remove the spark plug and install the whistle stop, ...
After checking for stored diagnostic trouble codes (DTCs), the wise technician checks service ...
Dissolved oxygen at The Gulf of Mexico’s “Dead Zone”
Drop Dead Healthy