Two technicians are discussing MAP sensors. Technician A says that the MAP sensor should be replaced if anything comes out of the sensor when the vacuum hose is removed from the sensor. Technician B says that the injector pulse width should increase when vacuum to the MAP sensor is increased. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
When testing a MAP sensor that produces an analog voltage signal with 18 in. hg. applied to the sensor, the sensor signal is l.4 volts. When 13 in. hg. is supplied to the sensor, the sensor signal should be which of these voltage values?
A) 2.6 B) 1.6 C) 1.4 D) 2.3
Washing hands and removing jewelry are two important safety habits all service technicians ...
To help locate how far the engine is being rotated, the technician is removing the distributor cap ...
A typical magnetic crankshaft position sensor.
A light shield over an optical sensor being installed before the rotor is attached.
Measuring the resistance of the ECT sensor. The resistance measurement can then be compared with ...
When the exhaust is lean, the output of a zirconia oxygen sensor is below 450 mV.