Two technicians are discussing MAP sensors. Technician A says that the MAP sensor should be replaced if anything comes out of the sensor when the vacuum hose is removed from the sensor. Technician B says that the injector pulse width should increase when vacuum to the MAP sensor is increased. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
When testing a MAP sensor that produces an analog voltage signal with 18 in. hg. applied to the sensor, the sensor signal is l.4 volts. When 13 in. hg. is supplied to the sensor, the sensor signal should be which of these voltage values?
A) 2.6 B) 1.6 C) 1.4 D) 2.3
Using an ice bath to test the fuel temperature sensor.
MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ...
On some vehicles equipped with an airflow sensor, a switch is used to energize the fuel pump. In ...
The fuelpressure sensor and fueltemperature sensor are often constructed together in one assembly ...
To measure fuel-injector resistance, a technician constructed a short wiring harness with a double ...
An OBD-II active test. The PCM opens the EGR valve and then monitors the MAP sensor and/or engine ...