« previous next »

Author Question: Never remove more material from the tip of a valve than ________ inches. A) 0.020 B) 0.050 C) ... (Read 60 times)

plus1

  • Hero Member
  • *****
  • Posts: 676
on: Jun 23, 2018
Never remove more material from the tip of a valve than ________ inches.
 
  A) 0.020 B) 0.050 C) 0.002 D) 0.001

Question 2

If an interference angle is machined on a valve or seat, the angle is usually ________.
 
  A) 0.005 degree B) 0.5-0.75 degree C) 1-3 degree D) 1 degree


lcapri7

  • Sr. Member
  • ****
  • Posts: 350
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Individuals are never “cured” of addictions. Instead, they learn how to manage their disease to lead healthy, balanced lives.

Did you know?

Walt Disney helped combat malaria by making an animated film in 1943 called The Winged Scourge. This short film starred the seven dwarfs and taught children that mosquitos transmit malaria, which is a very bad disease. It advocated the killing of mosquitos to stop the disease.

Did you know?

Allergies play a major part in the health of children. The most prevalent childhood allergies are milk, egg, soy, wheat, peanuts, tree nuts, and seafood.

Did you know?

About 3% of all pregnant women will give birth to twins, which is an increase in rate of nearly 60% since the early 1980s.

Did you know?

In women, pharmacodynamic differences include increased sensitivity to (and increased effectiveness of) beta-blockers, opioids, selective serotonin reuptake inhibitors, and typical antipsychotics.

An offset screwdriver is used to install or remove fasteners that do not have enough space above to ... An offset screwdriver is used to install or remove fasteners that do not have enough space above to ...
Remove all jewelry before performing service work on any vehicle. Remove all jewelry before performing service work on any vehicle.
Material Balance on Coolers in series Material Balance on Coolers in series
The camshaft is rotated in relation to the camshaft by the PCM to provide changes in valve timing. The camshaft is rotated in relation to the camshaft by the PCM to provide changes in valve timing.
A gauge reading with the needle fluctuating 3 to 9 inches Hg below normal often indicates a vacuum ... A gauge reading with the needle fluctuating 3 to 9 inches Hg below normal often indicates a vacuum ...
If the valve clearance (lash) is not correct, loosen the retaining nut and turn the valve adjusting ... If the valve clearance (lash) is not correct, loosen the retaining nut and turn the valve adjusting ...
Video: Stimulus (introduction)

For a complete list of videos, visit our video library