« previous next »

Author Question: Never remove more material from the tip of a valve than ________ inches. A) 0.020 B) 0.050 C) ... (Read 90 times)

plus1

  • Hero Member
  • *****
  • Posts: 676
on: Jun 23, 2018
Never remove more material from the tip of a valve than ________ inches.
 
  A) 0.020 B) 0.050 C) 0.002 D) 0.001

Question 2

If an interference angle is machined on a valve or seat, the angle is usually ________.
 
  A) 0.005 degree B) 0.5-0.75 degree C) 1-3 degree D) 1 degree


lcapri7

  • Sr. Member
  • ****
  • Posts: 350
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Amphetamine poisoning can cause intravascular coagulation, circulatory collapse, rhabdomyolysis, ischemic colitis, acute psychosis, hyperthermia, respiratory distress syndrome, and pericarditis.

Did you know?

About one in five American adults and teenagers have had a genital herpes infection—and most of them don't know it. People with genital herpes have at least twice the risk of becoming infected with HIV if exposed to it than those people who do not have genital herpes.

Did you know?

Nearly all drugs pass into human breast milk. How often a drug is taken influences the amount of drug that will pass into the milk. Medications taken 30 to 60 minutes before breastfeeding are likely to be at peak blood levels when the baby is nursing.

Did you know?

Atropine was named after the Greek goddess Atropos, the oldest and ugliest of the three sisters known as the Fates, who controlled the destiny of men.

Did you know?

Alcohol acts as a diuretic. Eight ounces of water is needed to metabolize just 1 ounce of alcohol.

Older participants remember more information than younger participants when material has emotional ... Older participants remember more information than younger participants when material has emotional ...
A vane phaser is used to move the camshaft using changes of oil pressure from the oil control valve. A vane phaser is used to move the camshaft using changes of oil pressure from the oil control valve.
Use caution if using a steel scraper to remove a gasket from aluminum parts. It is best to use a ... Use caution if using a steel scraper to remove a gasket from aluminum parts. It is best to use a ...
If the valve clearance (lash) is not correct, loosen the retaining nut and turn the valve adjusting ... If the valve clearance (lash) is not correct, loosen the retaining nut and turn the valve adjusting ...
Remove the heat source, and check the skin for redness. Massage the area, and notice muscle ... Remove the heat source, and check the skin for redness. Massage the area, and notice muscle ...
Mitral valve prolapse Mitral valve prolapse
Video: Four Giant Convection Cells oF Earth

For a complete list of videos, visit our video library