This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: What are the noise criteria curves? What will be an ideal ... (Read 58 times)

penguins

  • Hero Member
  • *****
  • Posts: 903
on: Jul 26, 2018
What are the noise criteria curves?
 
  What will be an ideal response?

Question 2

What is the difference between black iron and galvanized iron pipe?
 
  What will be an ideal response?


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

adf223

  • Sr. Member
  • ****
  • Posts: 304
Reply #1 on: Jul 26, 2018
Answer to Question 1

The industry uses a noise criteria system to designate the level of noise in the area where by the registers will be used. Each NC curve is assigned a number, in 5 decibel increments. The number corresponds to the decibel reading at approximately 1500 Hz.

Answer to Question 2

Black iron is the natural iron finish. Galvanized is dipped in zinc to make it more resistant to corrosion.


penguins

  • Hero Member
  • *****
  • Posts: 903
Reply #2 on: Jul 26, 2018
Both answers were spot on, thank you once again


adf223

  • Sr. Member
  • ****
  • Posts: 304
Reply #3 on: Jul 26, 2018
Great! Please up vote :D


« previous next »
 

Did you know?

As the western states of America were settled, pioneers often had to drink rancid water from ponds and other sources. This often resulted in chronic diarrhea, causing many cases of dehydration and death that could have been avoided if clean water had been available.

Did you know?

Atropine, along with scopolamine and hyoscyamine, is found in the Datura stramonium plant, which gives hallucinogenic effects and is also known as locoweed.

Did you know?

To combat osteoporosis, changes in lifestyle and diet are recommended. At-risk patients should include 1,200 to 1,500 mg of calcium daily either via dietary means or with supplements.

Did you know?

For about 100 years, scientists thought that peptic ulcers were caused by stress, spicy food, and alcohol. Later, researchers added stomach acid to the list of causes and began treating ulcers with antacids. Now it is known that peptic ulcers are predominantly caused by Helicobacter pylori, a spiral-shaped bacterium that normally exist in the stomach.

Did you know?

In 2006, a generic antinausea drug named ondansetron was approved. It is used to stop nausea and vomiting associated with surgery, chemotherapy, and radiation therapy.

Comparison of the titration curves of three weak acids Comparison of the titration curves of three weak acids
PMDD Diagnostic Criteria from the American Psychiatric Association PMDD Diagnostic Criteria from the American Psychiatric Association
Criteria for Trauma Center Designation Criteria for Trauma Center Designation
Suppose a country imports televisions. The country's supply and demand curves are shown in ... Suppose a country imports televisions. The country's supply and demand curves are shown in ...
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately
Sample lod score curves Sample lod score curves
Video: Glycolysis - Introduction to ATP and the burning of sugar

For a complete list of videos, visit our video library