This topic contains a solution. Click here to go to the answer

Author Question: How can a PH diagram be used to select the system compressor? What will be an ideal ... (Read 22 times)

londonang

  • Hero Member
  • *****
  • Posts: 540
How can a PH diagram be used to select the system compressor?
 
  What will be an ideal response?

Question 2

What are the constant quality lines?
 
  What will be an ideal response?



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

macagn

  • Sr. Member
  • ****
  • Posts: 345
Answer to Question 1

Plot the system on the PH diagram
Determine the amount of heat picked up in the evaporator by subtracting the enthalpy of the saturated mix entering the evaporator from the enthalpy of the gas leaving the evaporator.

Divide this into the required system capacity to get lbs/min of refrigerant Calculate the required gas volume by multiplying the volume of the gas entering the compressor times the lbs/min
Determine the compressor operating pressures from the condenser and evaporator horizontal lines.
Match compressor volume at the determined operating pressures

Answer to Question 2

The constant quality lines start at the bottom and extend upward toward the critical point located in top center of the saturation curve. These lines represent the percentage of vapor in the saturated refrigerant.




macagn

  • Sr. Member
  • ****
  • Posts: 345

 

Did you know?

The senior population grows every year. Seniors older than 65 years of age now comprise more than 13% of the total population. However, women outlive men. In the 85-and-over age group, there are only 45 men to every 100 women.

Did you know?

When blood is exposed to air, it clots. Heparin allows the blood to come in direct contact with air without clotting.

Did you know?

Every 10 seconds, a person in the United States goes to the emergency room complaining of head pain. About 1.2 million visits are for acute migraine attacks.

Did you know?

Blood is approximately twice as thick as water because of the cells and other components found in it.

Did you know?

In 1886, William Bates reported on the discovery of a substance produced by the adrenal gland that turned out to be epinephrine (adrenaline). In 1904, this drug was first artificially synthesized by Friedrich Stolz.

For a complete list of videos, visit our video library