This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Milling at an angle on a workpiece would be done in: A) G03 circular interpolation B) G01 linear ... (Read 13 times)

stevenposner

  • Hero Member
  • *****
  • Posts: 608
on: Jul 26, 2018
Milling at an angle on a workpiece would be done in:
 
  A) G03 circular interpolation B) G01 linear interpolation mode
  C) G43 linear motion mode D) G02 angle/arc mode

Question 2

On a wire EDM the wire never touches the material.
 
  Indicate whether the statement is true or false


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

scrocafella

  • Sr. Member
  • ****
  • Posts: 346
Reply #1 on: Jul 26, 2018
Answer to Question 1

B

Answer to Question 2

TRUE


stevenposner

  • Member
  • Posts: 608
Reply 2 on: Jul 26, 2018
Gracias!

skipfourms123

  • Member
  • Posts: 343
Reply 3 on: Yesterday
Excellent

« previous next »
 

Did you know?

The most destructive flu epidemic of all times in recorded history occurred in 1918, with approximately 20 million deaths worldwide.

Did you know?

Persons who overdose with cardiac glycosides have a better chance of overall survival if they can survive the first 24 hours after the overdose.

Did you know?

The first-known contraceptive was crocodile dung, used in Egypt in 2000 BC. Condoms were also reportedly used, made of animal bladders or intestines.

Did you know?

Interferon was scarce and expensive until 1980, when the interferon gene was inserted into bacteria using recombinant DNA technology, allowing for mass cultivation and purification from bacterial cultures.

Did you know?

Giardia is one of the most common intestinal parasites worldwide, and infects up to 20% of the world population, mostly in poorer countries with inadequate sanitation. Infections are most common in children, though chronic Giardia is more common in adults.

Insert the needle with the beveled side up. Keep the angle low, 10 to 30 degrees. Insert the needle with the beveled side up. Keep the angle low, 10 to 30 degrees.
How to perform linear approximations in calculus How to perform linear approximations in calculus
Using the same hand position as in Step 3, apply circular friction along paraspinal muscles of the ... Using the same hand position as in Step 3, apply circular friction along paraspinal muscles of the ...
A 600-kg car is going around a curve with a radius of 120 m that is banked at an angle of 20° ... A 600-kg car is going around a curve with a radius of 120 m that is banked at an angle of 20° ...
Linear programming problems Linear programming problems
Linear programming problems Linear programming problems
Video: Factors that affect conduction rates (myelination, axon diameter & temperature)

For a complete list of videos, visit our video library