This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Milling at an angle on a workpiece would be done in: A) G03 circular interpolation B) G01 linear ... (Read 44 times)

stevenposner

  • Hero Member
  • *****
  • Posts: 608
on: Jul 26, 2018
Milling at an angle on a workpiece would be done in:
 
  A) G03 circular interpolation B) G01 linear interpolation mode
  C) G43 linear motion mode D) G02 angle/arc mode

Question 2

On a wire EDM the wire never touches the material.
 
  Indicate whether the statement is true or false


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

scrocafella

  • Sr. Member
  • ****
  • Posts: 346
Reply #1 on: Jul 26, 2018
Answer to Question 1

B

Answer to Question 2

TRUE


stevenposner

  • Member
  • Posts: 608
Reply 2 on: Jul 26, 2018
Thanks for the timely response, appreciate it

patma1981

  • Member
  • Posts: 292
Reply 3 on: Yesterday
Excellent

« previous next »
 

Did you know?

Liver spots have nothing whatsoever to do with the liver. They are a type of freckles commonly seen in older adults who have been out in the sun without sufficient sunscreen.

Did you know?

Symptoms of kidney problems include a loss of appetite, back pain (which may be sudden and intense), chills, abdominal pain, fluid retention, nausea, the urge to urinate, vomiting, and fever.

Did you know?

Your skin wrinkles if you stay in the bathtub a long time because the outermost layer of skin (which consists of dead keratin) swells when it absorbs water. It is tightly attached to the skin below it, so it compensates for the increased area by wrinkling. This happens to the hands and feet because they have the thickest layer of dead keratin cells.

Did you know?

Bacteria have been found alive in a lake buried one half mile under ice in Antarctica.

Did you know?

More than 34,000 trademarked medication names and more than 10,000 generic medication names are in use in the United States.

Rib Cage Angles, Costal Angle, Angle of Ribs Rib Cage Angles, Costal Angle, Angle of Ribs
Parenteral medication administration. The angle of needle insertion for four different types of pare Parenteral medication administration. The angle of needle insertion for four different types of pare
Insert the needle with the beveled side up. Keep the angle low, 10 to 30 degrees. Insert the needle with the beveled side up. Keep the angle low, 10 to 30 degrees.
Using small, circular strokes, exfoliate the client’s neck and back. Using small, circular strokes, exfoliate the client’s neck and back.
Press into points along the neck with your thumb, one side at a time. Apply circular friction to ... Press into points along the neck with your thumb, one side at a time. Apply circular friction to ...
Energy in a Circular Orbit Energy in a Circular Orbit
Video: Introduction to Autism

For a complete list of videos, visit our video library