This topic contains a solution. Click here to go to the answer

Author Question: The crossfeed setover amount on a surface grinder for roughing should be about: A) 20 IPR B) 1/3 ... (Read 62 times)

torybrooks

  • Hero Member
  • *****
  • Posts: 500
The crossfeed setover amount on a surface grinder for roughing should be about:
 
  A) 20 IPR B) 1/3 the width of the wheel face
  C) 20 IPM D) 1/4 in. per stroke

Question 2

Roughing feeds in IPR on a small (12 in. swing) lathe should not exceed:
 
  A) .200 B) .005 C) .100 D) .015 - .020



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

anyusername12131

  • Sr. Member
  • ****
  • Posts: 327
Answer to Question 1

B

Answer to Question 2

D




torybrooks

  • Member
  • Posts: 500
Reply 2 on: Jul 26, 2018
Gracias!


fatboyy09

  • Member
  • Posts: 358
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

 

Did you know?

Long-term mental and physical effects from substance abuse include: paranoia, psychosis, immune deficiencies, and organ damage.

Did you know?

The use of salicylates dates back 2,500 years to Hippocrates's recommendation of willow bark (from which a salicylate is derived) as an aid to the pains of childbirth. However, overdosage of salicylates can harm body fluids, electrolytes, the CNS, the GI tract, the ears, the lungs, the blood, the liver, and the kidneys and cause coma or death.

Did you know?

If you could remove all of your skin, it would weigh up to 5 pounds.

Did you know?

If all the neurons in the human body were lined up, they would stretch more than 600 miles.

Did you know?

The heart is located in the center of the chest, with part of it tipped slightly so that it taps against the left side of the chest.

For a complete list of videos, visit our video library