This topic contains a solution. Click here to go to the answer

Author Question: How many thousandths of an inch of material should be left for a finishing cut, when roughing out a ... (Read 74 times)

ts19998

  • Hero Member
  • *****
  • Posts: 531
How many thousandths of an inch of material should be left for a finishing cut, when roughing out a cavity?
 
  A) .010 B) .030 C) .060 D) .080

Question 2

A small chip between the collars on a mill arbor will:
 
  A) Make the arbor harder to drive B) Both C and D
  C) Damage the cutter hub and collar faces D) Cause cutter axial runout



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

momolu

  • Sr. Member
  • ****
  • Posts: 320
Answer to Question 1

B

Answer to Question 2

B



ts19998

  • Hero Member
  • *****
  • Posts: 531
Both answers were spot on, thank you once again




 

Did you know?

In 1844, Charles Goodyear obtained the first patent for a rubber condom.

Did you know?

Symptoms of kidney problems include a loss of appetite, back pain (which may be sudden and intense), chills, abdominal pain, fluid retention, nausea, the urge to urinate, vomiting, and fever.

Did you know?

Liver spots have nothing whatsoever to do with the liver. They are a type of freckles commonly seen in older adults who have been out in the sun without sufficient sunscreen.

Did you know?

The most destructive flu epidemic of all times in recorded history occurred in 1918, with approximately 20 million deaths worldwide.

Did you know?

When blood is exposed to air, it clots. Heparin allows the blood to come in direct contact with air without clotting.

For a complete list of videos, visit our video library