This topic contains a solution. Click here to go to the answer

Author Question: How many thousandths of an inch of material should be left for a finishing cut, when roughing out a ... (Read 75 times)

ts19998

  • Hero Member
  • *****
  • Posts: 531
How many thousandths of an inch of material should be left for a finishing cut, when roughing out a cavity?
 
  A) .010 B) .030 C) .060 D) .080

Question 2

A small chip between the collars on a mill arbor will:
 
  A) Make the arbor harder to drive B) Both C and D
  C) Damage the cutter hub and collar faces D) Cause cutter axial runout



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

momolu

  • Sr. Member
  • ****
  • Posts: 320
Answer to Question 1

B

Answer to Question 2

B



ts19998

  • Hero Member
  • *****
  • Posts: 531
Both answers were spot on, thank you once again




 

Did you know?

About 100 new prescription or over-the-counter drugs come into the U.S. market every year.

Did you know?

The most destructive flu epidemic of all times in recorded history occurred in 1918, with approximately 20 million deaths worldwide.

Did you know?

In 2010, opiate painkllers, such as morphine, OxyContin®, and Vicodin®, were tied to almost 60% of drug overdose deaths.

Did you know?

Eating carrots will improve your eyesight. Carrots are high in vitamin A (retinol), which is essential for good vision. It can also be found in milk, cheese, egg yolks, and liver.

Did you know?

Atropine was named after the Greek goddess Atropos, the oldest and ugliest of the three sisters known as the Fates, who controlled the destiny of men.

For a complete list of videos, visit our video library