« previous next »

Author Question: The feed rate for roughing steel should be: A) One-fifth to one-tenth as much as the depth of cut ... (Read 108 times)

melina_rosy

  • Hero Member
  • *****
  • Posts: 531
on: Jul 26, 2018
The feed rate for roughing steel should be:
 
  A) One-fifth to one-tenth as much as the depth of cut
  B) From .003 to .005 inch
  C) Between .010 and .050 inch
  D) The one that gives the best surface finish

Question 2

Unalloyed nickel is the metal used for:
 
  A) Electroplating B) United States nickel coins
  C) Electric power lines D) All of the above


gstein359

  • Sr. Member
  • ****
  • Posts: 293
Reply #1 on: Jul 26, 2018
Answer to Question 1

A

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question

melina_rosy

  • Hero Member
  • *****
  • Posts: 531
Reply #2 on: Jul 26, 2018
Thank you!


gstein359

  • Sr. Member
  • ****
  • Posts: 293
Reply #3 on: Jul 26, 2018
Always glad to help...


« previous next »
 

Did you know?

Patients who have been on total parenteral nutrition for more than a few days may need to have foods gradually reintroduced to give the digestive tract time to start working again.

Did you know?

According to research, pregnant women tend to eat more if carrying a baby boy. Male fetuses may secrete a chemical that stimulates their mothers to step up her energy intake.

Did you know?

Oliver Wendell Holmes is credited with introducing the words "anesthesia" and "anesthetic" into the English language in 1846.

Did you know?

Thyroid conditions may make getting pregnant impossible.

Did you know?

No drugs are available to relieve parathyroid disease. Parathyroid disease is caused by a parathyroid tumor, and it needs to be removed by surgery.

Chloroplasts Feed the World Chloroplasts Feed the World
Firms Incorporated into U.S. Steel Firms Incorporated into U.S. Steel
Membership in this subculture is not easily awarded. Not only must high-steel ironworkers prove that ... Membership in this subculture is not easily awarded. Not only must high-steel ironworkers prove that ...
Use caution if using a steel scraper to remove a gasket from aluminum parts. It is best to use a ... Use caution if using a steel scraper to remove a gasket from aluminum parts. It is best to use a ...
Variations in Ocean Water Density with Depth Variations in Ocean Water Density with Depth
Classification of Burns by Depth Classification of Burns by Depth
Video: Status Epilepticus

For a complete list of videos, visit our video library