This topic contains a solution. Click here to go to the answer

Author Question: Compared with the feed rate for drilling the same material, the feed rate for reaming is ________ ... (Read 100 times)

robinn137

  • Hero Member
  • *****
  • Posts: 544
Compared with the feed rate for drilling the same material, the feed rate for reaming is ________ that for drilling.
 
  A) 2 times B) Equal C) 4 times D) One-half

Question 2

Reaming stock allowance in inches for machine reaming a one-half inch diameter hole should be?
 
  A) .015 B) .025 C) .005 D) .035



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

alexisweber49

  • Sr. Member
  • ****
  • Posts: 311
Answer to Question 1

A

Answer to Question 2

A




robinn137

  • Member
  • Posts: 544
Reply 2 on: Jul 26, 2018
:D TYSM


raili21

  • Member
  • Posts: 324
Reply 3 on: Yesterday
Great answer, keep it coming :)

 

Did you know?

The largest baby ever born weighed more than 23 pounds but died just 11 hours after his birth in 1879. The largest surviving baby was born in October 2009 in Sumatra, Indonesia, and weighed an astounding 19.2 pounds at birth.

Did you know?

According to the CDC, approximately 31.7% of the U.S. population has high low-density lipoprotein (LDL) or "bad cholesterol" levels.

Did you know?

Liver spots have nothing whatsoever to do with the liver. They are a type of freckles commonly seen in older adults who have been out in the sun without sufficient sunscreen.

Did you know?

Egg cells are about the size of a grain of sand. They are formed inside of a female's ovaries before she is even born.

Did you know?

In 1864, the first barbiturate (barbituric acid) was synthesized.

For a complete list of videos, visit our video library