« previous next »

Author Question: An AC voltage source, with a peak output of 200 V, is connected to a 25-W resistor. What is the rate ... (Read 151 times)

c0205847

  • Hero Member
  • *****
  • Posts: 531
on: Jul 28, 2018
An AC voltage source, with a peak output of 200 V, is connected to a 25-W resistor. What is the rate of energy dissipated due to heat in the resistor?
 a. 566 W
  c. 800 W
  b. 400 W
  d. 200 W

Question 2

Tripling the tension in a guitar string will change its natural frequency by what factor?
 a. 3
  c. 31/2
  b. 31/2
  d. 1.5


Rilsmarie951

  • Sr. Member
  • ****
  • Posts: 316
Reply #1 on: Jul 28, 2018
Answer to Question 1

C

Answer to Question 2

B


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Each year in the United States, there are approximately six million pregnancies. This means that at any one time, about 4% of women in the United States are pregnant.

Did you know?

The first oral chemotherapy drug for colon cancer was approved by FDA in 2001.

Did you know?

Symptoms of kidney problems include a loss of appetite, back pain (which may be sudden and intense), chills, abdominal pain, fluid retention, nausea, the urge to urinate, vomiting, and fever.

Did you know?

Pubic lice (crabs) are usually spread through sexual contact. You cannot catch them by using a public toilet.

Did you know?

In most cases, kidneys can recover from almost complete loss of function, such as in acute kidney (renal) failure.

Model of a longitudinal study in which 983 students were surveyed in 1984 and then again in 1985, 19 Model of a longitudinal study in which 983 students were surveyed in 1984 and then again in 1985, 19
AC ripple at the output terminal of the battery is more accurate than testing at the battery due ... AC ripple at the output terminal of the battery is more accurate than testing at the battery due ...
When the exhaust is lean, the output of a zirconia oxygen sensor is below 450 mV. When the exhaust is lean, the output of a zirconia oxygen sensor is below 450 mV.
Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ... Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ...
An injector tester being used to check the voltage drop through the injector while the tester is ... An injector tester being used to check the voltage drop through the injector while the tester is ...
Static Stability & Environmental Lapse Rate Static Stability & Environmental Lapse Rate
Video: Component of feedback systems & Communication and regulation of body systems

For a complete list of videos, visit our video library