« previous next »

Author Question: An AC voltage source, with a peak output of 200 V, is connected to a 25-W resistor. What is the rate ... (Read 152 times)

c0205847

  • Hero Member
  • *****
  • Posts: 531
on: Jul 28, 2018
An AC voltage source, with a peak output of 200 V, is connected to a 25-W resistor. What is the rate of energy dissipated due to heat in the resistor?
 a. 566 W
  c. 800 W
  b. 400 W
  d. 200 W

Question 2

Tripling the tension in a guitar string will change its natural frequency by what factor?
 a. 3
  c. 31/2
  b. 31/2
  d. 1.5


Rilsmarie951

  • Sr. Member
  • ****
  • Posts: 316
Reply #1 on: Jul 28, 2018
Answer to Question 1

C

Answer to Question 2

B


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

Cancer has been around as long as humankind, but only in the second half of the twentieth century did the number of cancer cases explode.

Did you know?

Green tea is able to stop the scent of garlic or onion from causing bad breath.

Did you know?

The Romans did not use numerals to indicate fractions but instead used words to indicate parts of a whole.

Did you know?

Each year in the United States, there are approximately six million pregnancies. This means that at any one time, about 4% of women in the United States are pregnant.

Did you know?

Many of the drugs used by neuroscientists are derived from toxic plants and venomous animals (such as snakes, spiders, snails, and puffer fish).

Defibrillator. Defibrillators are devices that supply a voltage charge to the heart in the hope of r Defibrillator. Defibrillators are devices that supply a voltage charge to the heart in the hope of r
Lilly Martin Spenser’s painting, Domestic Happiness (1844), reflects the change in attitudes toward Lilly Martin Spenser’s painting, Domestic Happiness (1844), reflects the change in attitudes toward
Distance from Initial Change in Membrane Potential vs. Voltage Change Relative to Initial Change Distance from Initial Change in Membrane Potential vs. Voltage Change Relative to Initial Change
An AC voltage is produced by a magnetic sensor. Most sensors should produce at least 0.1 volt AC ... An AC voltage is produced by a magnetic sensor. Most sensors should produce at least 0.1 volt AC ...
When the exhaust is rich, the output of a zirconia oxygen sensor is above 450 mV. When the exhaust is rich, the output of a zirconia oxygen sensor is above 450 mV.
A typical peak-and-hold fuel-injector waveform. Most fuel injectors that measure less than 6 ohms ... A typical peak-and-hold fuel-injector waveform. Most fuel injectors that measure less than 6 ohms ...
Video: Febrile Seizure

For a complete list of videos, visit our video library