This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Which of these sensors could be used to check for a poor PCM ground? A) ECT sensor B) IAT sensor ... (Read 595 times)

sammy

  • Hero Member
  • *****
  • Posts: 818
on: Jun 22, 2018
Which of these sensors could be used to check for a poor PCM ground?
 
  A) ECT sensor B) IAT sensor
  C) Oxygen (O2S) Sensor D) TP sensor

Question 2

Technician A says that the TP sensor signal voltage should be about 0.5 volt at idle and increase to about 2.5 volts at wide-open throttle (WOT). Technician B says that a TP sensor can be tested using a DMM (digital multimeter), DSO (digital storage oscilloscope), or scan tool. Which technician is correct?
 
  A) Technician A only B) Technician B only
  C) Both technicians D) Neither technician


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

joneynes

  • Sr. Member
  • ****
  • Posts: 376
Reply #1 on: Jun 22, 2018
Answer to Question 1

D

Answer to Question 2

B


sammy

  • Member
  • Posts: 818
Reply 2 on: Jun 22, 2018
Great answer, keep it coming :)

ryhom

  • Member
  • Posts: 366
Reply 3 on: Yesterday
Thanks for the timely response, appreciate it

« previous next »
 

Did you know?

No drugs are available to relieve parathyroid disease. Parathyroid disease is caused by a parathyroid tumor, and it needs to be removed by surgery.

Did you know?

The eye muscles are the most active muscles in the whole body. The external muscles that move the eyes are the strongest muscles in the human body for the job they have to do. They are 100 times more powerful than they need to be.

Did you know?

After a vasectomy, it takes about 12 ejaculations to clear out sperm that were already beyond the blocked area.

Did you know?

On average, someone in the United States has a stroke about every 40 seconds. This is about 795,000 people per year.

Did you know?

In 1864, the first barbiturate (barbituric acid) was synthesized.

Whenever a vehicle is raised off the ground, a safety stand should be placed under the frame, axle, ... Whenever a vehicle is raised off the ground, a safety stand should be placed under the frame, axle, ...
Be sure that the clips are properly installed. Start the engine and check for proper operation. Be sure that the clips are properly installed. Start the engine and check for proper operation.
When checking a waste spark-type ignition system, check that the secondary wires are attached to the ... When checking a waste spark-type ignition system, check that the secondary wires are attached to the ...
Many fuel-control oxygen sensors are located in the exhaust manifold near its outlet so that the ... Many fuel-control oxygen sensors are located in the exhaust manifold near its outlet so that the ...
A cross-sectional view of a typical zirconia oxygen sensor. A cross-sectional view of a typical zirconia oxygen sensor.
Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ... Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ...
Video: Primary Active Transport - electrochemical gradient and ion transport / water movement

For a complete list of videos, visit our video library