This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Which sensor has a switch that controls the electric fuel pump? A) Karman Vortex sensor B) Hot ... (Read 133 times)

JMatthes

  • Hero Member
  • *****
  • Posts: 578
on: Jun 22, 2018
Which sensor has a switch that controls the electric fuel pump?
 
  A) Karman Vortex sensor B) Hot wire MAF
  C) VAF D) Hot filter MAF

Question 2

Which type sensor uses a burn-off circuit?
 
  A) Hot wire MAF sensor B) Hot film MAF sensor
  C) Vane type air flow sensor D) Both A and B


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

mmpiza

  • Sr. Member
  • ****
  • Posts: 354
Reply #1 on: Jun 22, 2018
Answer to Question 1

C

Answer to Question 2

A


JMatthes

  • Member
  • Posts: 578
Reply 2 on: Jun 22, 2018
YES! Correct, THANKS for helping me on my review

Dominic

  • Member
  • Posts: 328
Reply 3 on: Yesterday
Gracias!

« previous next »
 

Did you know?

Although not all of the following muscle groups are commonly used, intramuscular injections may be given into the abdominals, biceps, calves, deltoids, gluteals, laterals, pectorals, quadriceps, trapezoids, and triceps.

Did you know?

More than one-third of adult Americans are obese. Diseases that kill the largest number of people annually, such as heart disease, cancer, diabetes, stroke, and hypertension, can be attributed to diet.

Did you know?

According to the CDC, approximately 31.7% of the U.S. population has high low-density lipoprotein (LDL) or "bad cholesterol" levels.

Did you know?

The Centers for Disease Control and Prevention (CDC) was originally known as the Communicable Disease Center, which was formed to fight malaria. It was originally headquartered in Atlanta, Georgia, since the Southern states faced the worst threat from malaria.

Did you know?

If you could remove all of your skin, it would weigh up to 5 pounds.

VORTEX MIXER VORTEX MIXER
MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ... MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ...
A cross-sectional view of a typical zirconia oxygen sensor. A cross-sectional view of a typical zirconia oxygen sensor.
Connections and settings necessary to measure fuel-injector resistance. Connections and settings necessary to measure fuel-injector resistance.
A typical peak-and-hold fuel-injector waveform. Most fuel injectors that measure less than 6 ohms ... A typical peak-and-hold fuel-injector waveform. Most fuel injectors that measure less than 6 ohms ...
Fossil fuel emissions and climate change Fossil fuel emissions and climate change
Video: Sister chromatids of a metaphase chromosome animation

For a complete list of videos, visit our video library