This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Technician A uses a dial indicator to check a hub flange for runout. Technician B says that ... (Read 283 times)

Beheh

  • Hero Member
  • *****
  • Posts: 520
on: Jun 23, 2018
Technician A uses a dial indicator to check a hub flange for runout. Technician B says that excessive runout on a wheel hub flange would cause low frequency vibrations. Which technician is correct?
 
  A) Technician A only B) Technician B only C) Both technicians D) Neither technician

Question 2

When changing the brake pads on a Ford Escape hybrid, what precaution must be taken before removing the brake pads?
 
  A) Block all 4 wheels
  B) Only change one pad at a time
  C) Always change the rear pads before changing the front pads
  D) Use a scan tool to enter Pad Service Mode


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

diesoon

  • Sr. Member
  • ****
  • Posts: 353
Reply #1 on: Jun 23, 2018
Answer to Question 1

C

Answer to Question 2

D


Beheh

  • Member
  • Posts: 520
Reply 2 on: Jun 23, 2018
Gracias!

jomama

  • Member
  • Posts: 346
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

« previous next »
 

Did you know?

The Romans did not use numerals to indicate fractions but instead used words to indicate parts of a whole.

Did you know?

There are actually 60 minerals, 16 vitamins, 12 essential amino acids, and three essential fatty acids that your body needs every day.

Did you know?

Increased intake of vitamin D has been shown to reduce fractures up to 25% in older people.

Did you know?

The modern decimal position system was the invention of the Hindus (around 800 AD), involving the placing of numerals to indicate their value (units, tens, hundreds, and so on).

Did you know?

There are 20 feet of blood vessels in each square inch of human skin.

A typical beginning technician tool set that includes the basic tools to get started. A typical beginning technician tool set that includes the basic tools to get started.
Be sure that the clips are properly installed. Start the engine and check for proper operation. Be sure that the clips are properly installed. Start the engine and check for proper operation.
Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ... Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ...
Use the test light to check for voltage at terminal 30 of the relay. The ignition may have to be in ... Use the test light to check for voltage at terminal 30 of the relay. The ignition may have to be in ...
After checking for stored diagnostic trouble codes (DTCs), the wise technician checks service ... After checking for stored diagnostic trouble codes (DTCs), the wise technician checks service ...
Check beans Check beans
Video: Stages of Mitosis - Prophase, Prometaphase, Metaphase, Anaphase & Telophase

For a complete list of videos, visit our video library