Author Question: The U-joint cap angle was measured to be 14.5 degrees. After rotating the driveshaft 90 degrees the ... (Read 234 times)

sarasara · **on:** Jun 23, 2018

The U-joint cap angle was measured to be 14.5 degrees. After rotating the driveshaft 90 degrees the angle of the yoke was measured to be 10 degrees. The working angle of the driveshaft is ________.

A) Too large B) OK
C) Too small D) Not enough information to answer the question

Question 2

Two light bulbs are wired in series and one bulb burns out (opens). Technician A says that the other bulb will work. Technician B says that the current will increase in the circuit because one electrical load (resistance) is no longer operating. Which technician is correct?

A) Technician A only B) Technician B only C) Both technicians D) Neither technician