Author Question: If you adjusting cut-out pressure on an accumulator charge valve, this would: a. change the ... (Read 98 times)

cartlidgeashley · **on:** Jun 23, 2018

If you adjusting cut-out pressure on an accumulator charge valve, this would:

a. change the maximum pressure the accumulator would be charged to
b. change the minimum pressure the accumulator would be charged to
c. change the maximum pressure that the boost pump could produce
d. change the minimum pressure the boost pump could produce

Question 2

The purpose of a residual check valve that is used in a master cylinder for hydraulic brakes is:

a. to allow fluid in behind the piston from the reservoir
b. to maintain boost pressure after the engine is shut down
c. to allow air into the reservoir
d. to keep a small amount of pressure in the brake lines at all times