This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Sometimes sensors will have to be __________________ for the ECM that it is sending a signal to so ... (Read 211 times)

darbym82

  • Hero Member
  • *****
  • Posts: 570
on: Jun 23, 2018
Sometimes sensors will have to be __________________ for the ECM that it is sending a signal to so that the ECM will know its zero point.
 
  a. calibrated
 b. reflashed
 c. turned on
 d. metered up

Question 2

When a clutch is adjusted this dimension should also be checked and corrected if necessary:
 
  a. pedal travel
 b. free play
 c. pressure plate travel d. pilot bearing clearance


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

johnpizzaz

  • Sr. Member
  • ****
  • Posts: 345
Reply #1 on: Jun 23, 2018
Answer to Question 1

A

Answer to Question 2

B


darbym82

  • Member
  • Posts: 570
Reply 2 on: Jun 23, 2018
Wow, this really help

xiaomengxian

  • Member
  • Posts: 311
Reply 3 on: Yesterday
Gracias!

« previous next »
 

Did you know?

The FDA recognizes 118 routes of administration.

Did you know?

In 2010, opiate painkllers, such as morphine, OxyContin®, and Vicodin®, were tied to almost 60% of drug overdose deaths.

Did you know?

In 1835 it was discovered that a disease of silkworms known as muscardine could be transferred from one silkworm to another, and was caused by a fungus.

Did you know?

Medication errors are three times higher among children and infants than with adults.

Did you know?

The heart is located in the center of the chest, with part of it tipped slightly so that it taps against the left side of the chest.

A typical oil pressure sending unit on a Ford V-8. A typical oil pressure sending unit on a Ford V-8.
A typical waveform from a knock sensor during a spark knock event. This signal is sent to the ... A typical waveform from a knock sensor during a spark knock event. This signal is sent to the ...
MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ... MAP sensors use three wires: 1.5 volt reference from the PCM 2. Sensor signal (output signal) 3. ...
Number and label designations for oxygen sensors. Bank 1 is the bank where cylinder number 1 is ... Number and label designations for oxygen sensors. Bank 1 is the bank where cylinder number 1 is ...
The averaging of an auditory evoked potential. Averaging increases the signal-to-noise ratio. The averaging of an auditory evoked potential. Averaging increases the signal-to-noise ratio.
Eukaryotic signal transduction systems involving membrane receptors (1–5)/ second messengers (1-4) Eukaryotic signal transduction systems involving membrane receptors (1–5)/ second messengers (1-4)
Video: Wound Repair Animation

For a complete list of videos, visit our video library