Two technicians are discussing disc brake rotor service. Technician A says that the inner races (bearing cups) should be removed from the rotor before it is mounted on the lathe. Technician B says that a non-directional finish on the rotor surfaces can be obtained by using sandpaper. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
Typical maximum rotor thickness variation (parallelism) specifications are ________.
A) 0.300 to 0.500 in. (8.0 to 13 mm) B) 0.0003 to 0.0005 in. (0.008 to 0.013 mm)
C) 0.030 to 0.050 in. (0.8 to 1.3 mm) D) 0.003 to 0.005 in. (0.08 to 0.13 mm)
Grace Service, a YMCA missionary, explained that these porters worked at the base of Mount Omei in S
Phrases that Decrease Customer Service Level
All brakes should be moistened with water or solvent to help prevent brake dust from becoming ...
To help locate how far the engine is being rotated, the technician is removing the distributor cap ...
Shown is the electronic circuit inside a ceramic disc MAP sensor used on many Chrysler engines. The ...
Do not interact with a service dog unless you have permission from its owner.