How should the vehicle be driven to best break in a newly overhauled engine?
A) At high speeds and loads B) At a steady low speed
C) At varying speeds and loads D) At idle speed and little or no load
Question 2
Which of these is the correct method for adjusting hydraulic lifters?
A) Adjust to zero clearance and then tighten a specified amount
B) Adjust to a zero clearance and loosen 3/4 of a turn
C) Adjust to a clearance of 0.008 and then loosen 1/2 turn
D) Adjust to 0.008 and cranks the engine; the valves will self-adjust
(a) With few ticks, moose retain a brown coat; (b) at high numbers of ticks, moose self-groom, destr
White steam is usually an indication of a blown (defective) cylinder head gasket that allows engine ...
A spark plug from an engine that had a blown head gasket. The white deposits could be from the ...
Hookup for testing fuel-pump current draw on any vehicle equipped with a fuel-pump relay.
A charcoal canister can be located under the hood or underneath the vehicle.
The demand for oil can be reduced significantly with the introduction of new higher vehicle mileage