« previous next »

Author Question: Before installing or starting a new or rebuilt engine, all of the following items should have been ... (Read 1325 times)

yoooooman

  • Hero Member
  • *****
  • Posts: 557
on: Jun 23, 2018
Before installing or starting a new or rebuilt engine, all of the following items should have been checked, EXCEPT ________.
 
  A) Battery fully charged
  B) Pre-lube engine and check for proper oil pressure
  C) Rear axle is topped off
  D) Check that all of the vacuum lines are correctly installed and routed

Question 2

Technician A says to carefully install all accessories when installing a replacement engine. Technician B says that when installing the transmission and other components on the engine block, be sure to use a box wrench to tighten all fasteners to factory specifications. Which technician is correct?
 
  A) Technician A B) Technician B C) Both technicians D) Neither technician


djpooyouma

  • Sr. Member
  • ****
  • Posts: 325
Reply #1 on: Jun 23, 2018
Answer to Question 1

C

Answer to Question 2

A


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

For pediatric patients, intravenous fluids are the most commonly cited products involved in medication errors that are reported to the USP.

Did you know?

Cyanide works by making the human body unable to use oxygen.

Did you know?

When intravenous medications are involved in adverse drug events, their harmful effects may occur more rapidly, and be more severe than errors with oral medications. This is due to the direct administration into the bloodstream.

Did you know?

Blood is approximately twice as thick as water because of the cells and other components found in it.

Did you know?

Women are 50% to 75% more likely than men to experience an adverse drug reaction.

Typical computer-controlled diesel engine fuel injectors. Typical computer-controlled diesel engine fuel injectors.
A thermostat stuck in the open position caused the engine to operate too cold. The vehicle failed ... A thermostat stuck in the open position caused the engine to operate too cold. The vehicle failed ...
Weak valve springs will produce a normal reading at idle, but as engine speed increases, the needle ... Weak valve springs will produce a normal reading at idle, but as engine speed increases, the needle ...
A steady needle reading that drops 2 or 3 inches Hg when the engine speed is increased slightly ... A steady needle reading that drops 2 or 3 inches Hg when the engine speed is increased slightly ...
After connecting the shutoff tool, start the engine and operate all accessories. Stop the engine ... After connecting the shutoff tool, start the engine and operate all accessories. Stop the engine ...
Typical engine analyzer hookup that includes a scope display. (1) Coil wire on top of the ... Typical engine analyzer hookup that includes a scope display. (1) Coil wire on top of the ...
Video: Dendrite Animation

For a complete list of videos, visit our video library