Technician A says that a voltage-drop test of the charging circuit should only be performed when current is NOT flowing through the circuit. Technician B says to connect the leads of a voltmeter to the positive and negative terminals of the battery to measure the voltage drop of the charging system. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Question 2
When the spindle contacts the anvil on a standard 0 -1 English micrometer, it should read which of these values in inches?
A) 0.050 B) 0.001 C) 0.025 D) 0.000
The Ames test for mutagenicity.
Performing a Spirometry Test to Measure Forced Vital Capacity
A model for the operation of voltage-gated sodium channels.
Badly burned exhaust valve. A compression test could have detected a problem, and a cylinder ...
When the O2S voltage rises above 450 mV, the PCM starts to control the fuel mixture based on ...
A vehicle being tested during an enhanced emissions test.