A voltmeter was used to check the coolant and a reading of 0.2 volt with the engine off was measured. A reading of 0.8 volt was measured with the engine running and all electrical accessories turned on. Technician A says that the coolant should be flushed to solve the galvanic activity. Technician B says that the ground wires and connections should be inspected and repaired to solve the electrolysis problem. Which technician is correct?
A) Technician A B) Technician B C) Both technicians D) Neither technician
Question 2
What tool should be used to loosen or tighten brake or fuel lines?
A) Locking pliers B) Line wrench
C) Torque wrench D) Multigroove adjustable pliers
Used antifreeze coolant should be kept separate and stored in a leakproof container until it can be ...
The paper test involves holding a piece of paper near the tailpipe of an idling engine. A good ...
An intake manifold gasket that failed and allowed coolant to be drawn into the cylinder(s).
Testing a dual cell wideband oxygen sensor can be done using a voltmeter or a scope. The meter ...
A fuel-pressure reading does not confirm that there is enough fuel volume for the engine to ...
A bank statement shows a balance of $2,970.31 The check register of the account owner shows an ...