« previous next »

Author Question: If two insulated wires were to melt together where the copper conductors touched each other, the ... (Read 243 times)

londonang

  • Hero Member
  • *****
  • Posts: 540
on: Jun 23, 2018
If two insulated wires were to melt together where the copper conductors touched each other, the type of failure would be called a(an) __________.
 
  A) Open B) Floating ground C) Short-to-voltage D) Short-to-ground

Question 2

What type of manual includes time needed to perform service procedures?
 
  A) Unit repair manuals B) Parts guide
  C) Flat rate manuals D) Owners manuals


dlook33

  • Sr. Member
  • ****
  • Posts: 344
Reply #1 on: Jun 23, 2018
Answer to Question 1

C

Answer to Question 2

C


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
« previous next »
 

Did you know?

An identified risk factor for osteoporosis is the intake of excessive amounts of vitamin A. Dietary intake of approximately double the recommended daily amount of vitamin A, by women, has been shown to reduce bone mineral density and increase the chances for hip fractures compared with women who consumed the recommended daily amount (or less) of vitamin A.

Did you know?

More than 20 million Americans cite use of marijuana within the past 30 days, according to the National Survey on Drug Use and Health (NSDUH). More than 8 million admit to using it almost every day.

Did you know?

Critical care patients are twice as likely to receive the wrong medication. Of these errors, 20% are life-threatening, and 42% require additional life-sustaining treatments.

Did you know?

It is believed that humans initially contracted crabs from gorillas about 3 million years ago from either sleeping in gorilla nests or eating the apes.

Did you know?

ACTH levels are normally highest in the early morning (between 6 and 8 A.M.) and lowest in the evening (between 6 and 11 P.M.). Therefore, a doctor who suspects abnormal levels looks for low ACTH in the morning and high ACTH in the evening.

copper copper
A gasoline testing kit, including an insulated container where water at 100°F is used to heat a ... A gasoline testing kit, including an insulated container where water at 100°F is used to heat a ...
When checking a waste spark-type ignition system, check that the secondary wires are attached to the ... When checking a waste spark-type ignition system, check that the secondary wires are attached to the ...
A ring link network reduces the number of wires it takes to interconnect all of the modules. A ring link network reduces the number of wires it takes to interconnect all of the modules.
How much heat energy in Joules is required to heat 16.0 g of copper from 23.0 °C How much heat energy in Joules is required to heat 16.0 g of copper from 23.0 °C
How much heat energy in Joules is required to heat 16.0 g of copper from 23.0 °C How much heat energy in Joules is required to heat 16.0 g of copper from 23.0 °C
Video: Role of the urinary system - acidosis and alkalosis

For a complete list of videos, visit our video library