Technician A says that a steel piston should be cleaned with sandpaper to remove rust. Technician B says that brake assembly fluid or clean brake fluid should be used to lubricate the caliper pistons before installing in the caliper. Which technician is correct?
A) Technician A only B) Technician B only C) Both technicians D) Neither technician
Question 2
After a disc brake pad replacement, the brake pedal went to the floor the first time the brake pedal was depressed. The most likely cause was ________.
A) Lack of proper lubrication of the caliper slides B) Normal operation
C) Air in the lines D) Improper disc brake pad installation
Suctioning a tracheostomy to remove secretions.
This 1900 photograph of steel factories at night in Duquesne, near Pittsburgh, was tinted by hand. S
Compression ratio is the ratio of the total cylinder volume (when the piston is at the bottom of ...
The exhaust gases are pushed out of the cylinder by the piston on the exhaust stroke.
A technician-made adapter used to test exhaust system back pressure.
Remove cold source, and check the knee for changes. Notice skin color and changes in swelling around ...