The mode of pressure ventilation that is patient- or ...

[fbq8i]

The mode of pressure ventilation that is patient- or time-triggered and flow-cycled is which of the following?
 
  a. Volume support (VS)
  b. Pressure support ventilation (PSV)
  c. Pressure-controlled continuous mandatory ventilation (PC-CMV)
  d. Bilevel positive airway pressure (bilevel PAP)

Question 2

A patient receiving mechanical ventilation via pressure-regulated volume control (PRVC) has a set target volume of 500 mL with an upper pressure limit setting of 35 cm H2O.
 
  During the respiratory therapist's first patient ventilator system check, 25 cm H2O was needed to deliver the set volume. Several hours later the pressure to deliver the set volume is 15 cm H2O. The respiratory therapist should do which of the following?
  a. Switch the patient to pressure support ventilation (PSV).
  b. No action should be taken.
  c. The set volume should be reduced.
  d. The upper pressure limit should be re-duced.

[aham8f]

Answer to Question 1

ANS: D
Volume support (VS) and pressure support ventilation (PSV) are both patient-triggered and flow-cycled. Pressure-controlled continuous mandatory ventilation (PC-CMV) is patient- or time-triggered and time-cycled. Bilevel PAP is patient- or time-triggered and flow-cycled.

Answer to Question 2

ANS: D
The upper pressure limit should be reduced so that the lungs are protected from pressures that would be too high for the recovering lungs. There is nothing in this scenario that gives any clues to the fact that the patient should be switched to PSV. Not taking any action in this situation could cause harm to the patient if the pressure were to rise suddenly, as with a cough or forcible exhalation.

[fbq8i]

Thanks for the timely response, appreciate it

[TheDev123]

Great answer, keep it coming