This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: What is a continuity tester used for? What will be an ideal ... (Read 80 times)

amal

  • Hero Member
  • *****
  • Posts: 572
on: Jul 21, 2018
What is a continuity tester used for?
 
  What will be an ideal response?

Question 2

What is a single-pole switch designed for?
 
  What will be an ideal response?


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

macmac

  • Sr. Member
  • ****
  • Posts: 343
Reply #1 on: Jul 21, 2018
Answer to Question 1

A continuity tester is a device to determine whether electricity can flow between two points.

Answer to Question 2

A single-pole switch is designed to be the only switch in a circuit.


amal

  • Member
  • Posts: 572
Reply 2 on: Jul 21, 2018
Thanks for the timely response, appreciate it

marict

  • Member
  • Posts: 304
Reply 3 on: Yesterday
:D TYSM

« previous next »
 

Did you know?

The most destructive flu epidemic of all times in recorded history occurred in 1918, with approximately 20 million deaths worldwide.

Did you know?

The largest baby ever born weighed more than 23 pounds but died just 11 hours after his birth in 1879. The largest surviving baby was born in October 2009 in Sumatra, Indonesia, and weighed an astounding 19.2 pounds at birth.

Did you know?

Many medications that are used to treat infertility are injected subcutaneously. This is easy to do using the anterior abdomen as the site of injection but avoiding the area directly around the belly button.

Did you know?

Studies show that systolic blood pressure can be significantly lowered by taking statins. In fact, the higher the patient's baseline blood pressure, the greater the effect of statins on his or her blood pressure.

Did you know?

A good example of polar molecules can be understood when trying to make a cake. If water and oil are required, they will not mix together. If you put them into a measuring cup, the oil will rise to the top while the water remains on the bottom.

This battery-powered tester uses light-emitting diodes (LEDs), meter lead terminals, and two small ... This battery-powered tester uses light-emitting diodes (LEDs), meter lead terminals, and two small ...
The first step is to verify the proper operation of the tester by measuring the air frequency by ... The first step is to verify the proper operation of the tester by measuring the air frequency by ...
A close-up showing the recessed center electrode on a spark tester. It is recessed 3/8 inch into ... A close-up showing the recessed center electrode on a spark tester. It is recessed 3/8 inch into ...
An injector tester being used to check the voltage drop through the injector while the tester is ... An injector tester being used to check the voltage drop through the injector while the tester is ...
Under ideal conditions, a single cell of the bacterium E. coli would divide every 20 minutes to ... Under ideal conditions, a single cell of the bacterium E. coli would divide every 20 minutes to ...
For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately For the circuit in Figure 1, assume ideal diodes. The peak inverse voltage is approximately
Video: Audiology

For a complete list of videos, visit our video library