This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: The device used to prove that a burner flame is present in a furnace with hot surface ignition is a ... (Read 81 times)

abern

  • Hero Member
  • *****
  • Posts: 533
on: Jul 24, 2018
The device used to prove that a burner flame is present in a furnace with hot surface ignition is a _____.
 
  a. thermocouple
  b. glow coil
  c. flame-sensing rod
  d. bimetal switch

Question 2

The minimum voltage reading you should expect when testing a thermocouple under load is _____.
 
  a. 24V
  b. 10mV
  c. 18V
  d. 30mV


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

diesoon

  • Sr. Member
  • ****
  • Posts: 353
Reply #1 on: Jul 24, 2018
Answer to Question 1

c

Answer to Question 2

b


abern

  • Member
  • Posts: 533
Reply 2 on: Jul 24, 2018
:D TYSM

helenmarkerine

  • Member
  • Posts: 324
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

« previous next »
 

Did you know?

Vital signs (blood pressure, temperature, pulse rate, respiration rate) should be taken before any drug administration. Patients should be informed not to use tobacco or caffeine at least 30 minutes before their appointment.

Did you know?

As of mid-2016, 18.2 million people were receiving advanced retroviral therapy (ART) worldwide. This represents between 43–50% of the 34–39.8 million people living with HIV.

Did you know?

To combat osteoporosis, changes in lifestyle and diet are recommended. At-risk patients should include 1,200 to 1,500 mg of calcium daily either via dietary means or with supplements.

Did you know?

Eat fiber! A diet high in fiber can help lower cholesterol levels by as much as 10%.

Did you know?

The FDA recognizes 118 routes of administration.

Wiring diagram of a typical Ford electronic ignition. Wiring diagram of a typical Ford electronic ignition.
A typical two-wire coil-on-plug ignition system showing the triggering and the switching being ... A typical two-wire coil-on-plug ignition system showing the triggering and the switching being ...
Clip-on adapters are used with an ignition system that uses an integral ignition coil. Clip-on adapters are used with an ignition system that uses an integral ignition coil.
Changes in Land Configuration and Surface Characteristics Changes in Land Configuration and Surface Characteristics
Place the infant faceup on a soft surface, such as a towel, and remove his or her clothing. With one ... Place the infant faceup on a soft surface, such as a towel, and remove his or her clothing. With one ...
Polar ice caps lose mass as surface ice melts Polar ice caps lose mass as surface ice melts
Video: How a Urinalysis is Performed

For a complete list of videos, visit our video library