This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Although this is usually done at the factory or during proving, a typical commissioning procedure ... (Read 35 times)

appyboo

  • Hero Member
  • *****
  • Posts: 527
on: Jul 24, 2018
Although this is usually done at the factory or during proving, a typical commissioning procedure includes verifying that the instruments have been _____.
 
  A) zoned B) toned C) calibrated D) tuned

Question 2

The kind of belt that is used on small sheaves and can handle bending stress well is the _____ belt.
 
  A) A42 B) notched C) FHP D) roller


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

aadams68

  • Sr. Member
  • ****
  • Posts: 317
Reply #1 on: Jul 24, 2018
Answer to Question 1

C

Answer to Question 2

B


appyboo

  • Hero Member
  • *****
  • Posts: 527
Reply #2 on: Jul 24, 2018
Both answers were spot on, thank you once again


aadams68

  • Sr. Member
  • ****
  • Posts: 317
Reply #3 on: Jul 24, 2018
Great! Please up vote :D


« previous next »
 

Did you know?

Asthma attacks and symptoms usually get started by specific triggers (such as viruses, allergies, gases, and air particles). You should talk to your doctor about these triggers and find ways to avoid or get rid of them.

Did you know?

Less than one of every three adults with high LDL cholesterol has the condition under control. Only 48.1% with the condition are being treated for it.

Did you know?

Between 1999 and 2012, American adults with high total cholesterol decreased from 18.3% to 12.9%

Did you know?

Walt Disney helped combat malaria by making an animated film in 1943 called The Winged Scourge. This short film starred the seven dwarfs and taught children that mosquitos transmit malaria, which is a very bad disease. It advocated the killing of mosquitos to stop the disease.

Did you know?

People about to have surgery must tell their health care providers about all supplements they take.

A typical office layout. A typical office layout.
A cutaway of a typical water pump showing the long bearing assembly and the seal. The weep hole is ... A cutaway of a typical water pump showing the long bearing assembly and the seal. The weep hole is ...
A typical bus system showing module CAN communications and twisted pairs of wire. A typical bus system showing module CAN communications and twisted pairs of wire.
A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ... A typical two-step ECT circuit showing that when the coolant temperature is low, the PCM applies a ...
A cross-sectional view of a typical zirconia oxygen sensor. A cross-sectional view of a typical zirconia oxygen sensor.
A factory replacement unit for a CSFI unit that has individual injectors at the ends that go into ... A factory replacement unit for a CSFI unit that has individual injectors at the ends that go into ...
Video: Oxygen transport: association and dissociation & Factors that affect hemoglobin's saturation with O2

For a complete list of videos, visit our video library