« previous next »

Author Question: Using Ohm's law, what is the amp draw of a circuit with a voltage of 240 V and a resistance of 10 ? ... (Read 46 times)

brutforce

  • Hero Member
  • *****
  • Posts: 540
on: Jul 24, 2018
Using Ohm's law, what is the amp draw of a circuit with a voltage of 240 V and a resistance of 10 ?
 
  A) 2.4 A B) 34 A C) 240 A D) 24 A

Question 2

How does one detect a leak in a low-pressure system?
 
  A) Slower recovery rates B) High pressure increases
  C) Full system shutdowns D) An extended purging operation


Andromeda18

  • Sr. Member
  • ****
  • Posts: 336
Reply #1 on: Jul 24, 2018
Answer to Question 1

D

Answer to Question 2

D


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question

brutforce

  • Hero Member
  • *****
  • Posts: 540
Reply #2 on: Jul 24, 2018
TY


Andromeda18

  • Sr. Member
  • ****
  • Posts: 336
Reply #3 on: Jul 24, 2018
You're welcome


« previous next »
 

Did you know?

Cyanide works by making the human body unable to use oxygen.

Did you know?

Asthma cases in Americans are about 75% higher today than they were in 1980.

Did you know?

The FDA recognizes 118 routes of administration.

Did you know?

Only 12 hours after an egg cell is fertilized by a sperm cell, the egg cell starts to divide. As it continues to divide, it moves along the fallopian tube toward the uterus at about 1 inch per day.

Did you know?

Anti-aging claims should not ever be believed. There is no supplement, medication, or any other substance that has been proven to slow or stop the aging process.

Shown is the electronic circuit inside a ceramic disc MAP sensor used on many Chrysler engines. The ... Shown is the electronic circuit inside a ceramic disc MAP sensor used on many Chrysler engines. The ...
Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ... Use a DMM set to read DC volts to check the voltage drop of the positive circuit to the fuel ...
If an injector has the specified resistance, this does not mean that it is okay. This injector had ... If an injector has the specified resistance, this does not mean that it is okay. This injector had ...
Set the meter to read ohms (V) and measure the resistance of the relay coil. The usual reading for ... Set the meter to read ohms (V) and measure the resistance of the relay coil. The usual reading for ...
A model for voltage-gating in the channel A model for voltage-gating in the channel
How much voltage does the resistor drop in Figure 10-2? How much voltage does the resistor drop in Figure 10-2?
Video: Introduction to Breast Cancer

For a complete list of videos, visit our video library