Author Question: When drawing a PH diagram of an operating system, how is placement of the metering device line ... (Read 71 times)

bobthebuilder · **on:** Jul 24, 2018

When drawing a PH diagram of an operating system, how is placement of the metering device line determined?

A) The metering device line starts where the compressor line crosses the temperature of the liquid line and then drops straight down until it crosses the condenser line.
B) The metering device line starts where the condenser line crosses the temperature of the liquid line and then drops straight down until it crosses the compressor line.
C) The metering device line starts where the condenser line crosses the temperature of the liquid line and then goes straight across until it crosses the compressor line.
D) The metering device line starts where the condenser line crosses the temperature of the liquid line and then drops straight down until it crosses the evaporator line.

Question 2

How is placement of the compressor line determined when drawing a PH diagram of an operating system?

A) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant enthalpy lines up until it crosses the condenser line.
B) The compressor line starts where the condenser line crosses the suction line temperature and follows the constant entropy lines up until it crosses the evaporator line.
C) Measure the suction-line temperature entering the compressor. Find where the evaporator line crosses this suction line temperature in the superheated area.
D) The compressor line starts where the evaporator line crosses the suction line temperature and follows the constant quality lines up until it crosses the condenser line.