Why might closing the oxygen cylinder, then the acetylene cylinder, then bleeding first the oxygen line, then finally the acetylene line at the end of a brazing project create a hazardous situation?
A) The acetylene and oxygen lines should be bled simultaneously.
B) The acetylene and oxygen cylinders should be closed simultaneously.
C) The acetylene cylinder should be closed first.
D) The last gas to go through the torch will be a flammable gas.
Question 2
When the heat load on the evaporator increases, the automatic expansion valve:
A) Closes to keep the pressure from increasing.
B) Does nothing because AEVs are not modulating devices.
C) Sends a signal to the electronic control board indicating the change.
D) Opens to feed more refrigerant.
The downward movement of the piston draws the air–fuel mixture into the cylinder through the ...
Automotive engine cylinder arrangements.
Diesel combustion occurs when fuel is injected into the hot, highly compressed air in the cylinder.
Testing a dual cell wideband oxygen sensor can be done using a voltmeter or a scope. The meter ...
Cylinder Seal and Its Modern Impression
Cylinder Power Balance Test