This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Why are copper fittings cleaned before soldering or brazing? A) To remove oxides B) To enhance ... (Read 76 times)

casperchen82

  • Hero Member
  • *****
  • Posts: 540
on: Jul 24, 2018
Why are copper fittings cleaned before soldering or brazing?
 
  A) To remove oxides
  B) To enhance the aesthetic appearance of the completed joint
  C) To create enough clearance so that the pipe will fit into the fitting
  D) To make it easier to see the junction between the fitting and the pipe

Question 2

Which type of metering device used on flooded evaporators opens to admit more liquid refrigerant into the evaporator when the liquid level in the evaporator drops?
 
  A) High-side float B) Low-side float
  C) Automatic expansion valve D) Electronic expansion valve


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

apple

  • Sr. Member
  • ****
  • Posts: 352
Reply #1 on: Jul 24, 2018
Answer to Question 1

A

Answer to Question 2

B


casperchen82

  • Member
  • Posts: 540
Reply 2 on: Jul 24, 2018
:D TYSM

Liamb2179

  • Member
  • Posts: 365
Reply 3 on: Yesterday
Excellent

« previous next »
 

Did you know?

Vital signs (blood pressure, temperature, pulse rate, respiration rate) should be taken before any drug administration. Patients should be informed not to use tobacco or caffeine at least 30 minutes before their appointment.

Did you know?

Drug-induced pharmacodynamic effects manifested in older adults include drug-induced renal toxicity, which can be a major factor when these adults are experiencing other kidney problems.

Did you know?

Certain chemicals, after ingestion, can be converted by the body into cyanide. Most of these chemicals have been removed from the market, but some old nail polish remover, solvents, and plastics manufacturing solutions can contain these substances.

Did you know?

ACTH levels are normally highest in the early morning (between 6 and 8 A.M.) and lowest in the evening (between 6 and 11 P.M.). Therefore, a doctor who suspects abnormal levels looks for low ACTH in the morning and high ACTH in the evening.

Did you know?

Though “Krazy Glue” or “Super Glue” has the ability to seal small wounds, it is not recommended for this purpose since it contains many substances that should not enter the body through the skin, and may be harmful.

Sunlight on Mars is dimmer than on Earth. This photo of a Martian sunset was imaged by Mars Pathfind Sunlight on Mars is dimmer than on Earth. This photo of a Martian sunset was imaged by Mars Pathfind
Remove all of the spark plugs. Be sure to mark the spark plug wires so that they can be reinstalled ... Remove all of the spark plugs. Be sure to mark the spark plug wires so that they can be reinstalled ...
Continue the process until the canister is empty and the engine stalls. Remove the cleaning ... Continue the process until the canister is empty and the engine stalls. Remove the cleaning ...
Remove the heat source, and check the skin for redness. Massage the area, and notice muscle ... Remove the heat source, and check the skin for redness. Massage the area, and notice muscle ...
Which outcome corresponds to the combination of copper(II) and sulfide ions shown in the ... Which outcome corresponds to the combination of copper(II) and sulfide ions shown in the ...
Video: Heart sounds

For a complete list of videos, visit our video library