To take angularity and offset measurements at the same time, set ...

[Sufayan.ah]

To take angularity and offset measurements at the same time, set up two dial indicators ________.
 
  A) with one on each face of the coupling halves
  B) on both the face and the OD of the MTBM coupling half
  C) on both the face and the OD of the STAT coupling half
  D) with one on each OD of the coupling halves

Question 2

When the coupling half must be lowered to correct vertical offset misalignment, shims are placed under the ________ of the MTBM.
 
  A) nearest end of the base plate B) rear lugs
  C) front lugs D) farthest end of the base plate

[Sammyo]

Answer to Question 1

C

Answer to Question 2

B

[Sufayan.ah]

Gracias!

[xiazhe]

Thanks for the timely response, appreciate it