Author Question: The best way to remove a belt from a belt drive is to A) Loosen the mount on the drive pulley to ... (Read 142 times)

iveyjurea · **on:** Jul 26, 2018

The best way to remove a belt from a belt drive is to

A) Loosen the mount on the drive pulley to create slack in the belt
B) Remove the drive pulley from the motor
C) Roll the belt over the edge of the larger pulley
D) Roll the belt over the edge of the smaller pulley

Question 2

Why would the compressor run longer when system demand is not high?

A) The system registers a below normal operating pressure.
B) The system does not have the correct amount of refrigerant.
C) The system was precharged with too much refrigerant.
D) The system is clogged with debris.