How are the blower and coil arranged in most heat pump blower-coils?
A) the coil is before the blower - the fan draws air across the coil
B) the coil is after the blower - the fan draws air across the coil
C) the coil is after the blower - the fan forces air across the coil
D) the coil is before the blower - the fan forces air across the coil
Question 2
Why are both lines of a mini-split system insulated?
A) because it can connect up to 8 sections B) because they do not have any ductwork
C) because there is only one metering device D) because the entire unit is outdoors
Aquamatic pad and heating unit provide dry heat treatment to a patient’s arm.
In a gear-type oil pump, the oil flows through the pump around the outside of each gear. This is an ...
Checking an ignition coil using a multimeter set to read ohms.
The pumping action of an impeller or rotary vane pump.
A typical direct-injection system uses two pumps—one low-pressure electric pump in the fuel tank ...
Cover heat source to slow cooling by placing a towel over it.