This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: What is normally used for the ground terminal on a spark igniter? A) Spark igniters do not ... (Read 21 times)

lak

  • Hero Member
  • *****
  • Posts: 546
on: Jul 26, 2018
What is normally used for the ground terminal on a spark igniter?
 
  A) Spark igniters do not require a ground because they operate on DC voltage
  B) The white neutral wire supplying current to the furnace
  C) The burner assembly
  D) A separate ground rod

Question 2

Thrust bearings are typically applied to a shaft using a(n) _____.
 
  a. torch
  b. arbor press or hydraulic press
  c. brass hammer
  d. wooden block and a rubber mallet


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

polinasid

  • Sr. Member
  • ****
  • Posts: 344
Reply #1 on: Jul 26, 2018
Answer to Question 1

C

Answer to Question 2

b


lak

  • Member
  • Posts: 546
Reply 2 on: Jul 26, 2018
Great answer, keep it coming :)

rleezy04

  • Member
  • Posts: 322
Reply 3 on: Yesterday
YES! Correct, THANKS for helping me on my review

« previous next »
 

Did you know?

Most childhood vaccines are 90–99% effective in preventing disease. Side effects are rarely serious.

Did you know?

Asthma cases in Americans are about 75% higher today than they were in 1980.

Did you know?

Malaria was not eliminated in the United States until 1951. The term eliminated means that no new cases arise in a country for 3 years.

Did you know?

Chronic marijuana use can damage the white blood cells and reduce the immune system's ability to respond to disease by as much as 40%. Without a strong immune system, the body is vulnerable to all kinds of degenerative and infectious diseases.

Did you know?

Cutaneous mucormycosis is a rare fungal infection that has been fatal in at least 29% of cases, and in as many as 83% of cases, depending on the patient's health prior to infection. It has occurred often after natural disasters such as tornados, and early treatment is essential.

The initial timing is where the spark plug fires at idle speed. The computer then advances the ... The initial timing is where the spark plug fires at idle speed. The computer then advances the ...
When checking a waste spark-type ignition system, check that the secondary wires are attached to the ... When checking a waste spark-type ignition system, check that the secondary wires are attached to the ...
Raster is the best scope position to view the spark lines of all the cylinders to check for ... Raster is the best scope position to view the spark lines of all the cylinders to check for ...
A downward-sloping spark line usually indicates high secondary ignition system resistance or an ... A downward-sloping spark line usually indicates high secondary ignition system resistance or an ...
A typical low-side driver (LSD) which uses a control module to control the ground side of the relay ... A typical low-side driver (LSD) which uses a control module to control the ground side of the relay ...
Use the test light to check for voltage at terminal 30 of the relay. The ignition may have to be in ... Use the test light to check for voltage at terminal 30 of the relay. The ignition may have to be in ...
Video: Interpreting a cladogram Animation

For a complete list of videos, visit our video library