Half side milling cutters are: A) Use to straddle mill B) Used ...

[javeds]

Half side milling cutters are:
 
  A) Use to straddle mill B) Used to cut shallow grooves
  C) Used to cut deep grooves D) All of the above

Question 2

After the depth of cut is set:
 
  A) Tighten the knee locking clamps B) Increase it by .010 inch to reduce the over cut
  C) Take a trial cut D) None of the above

[Ahernandez18]

Answer to Question 1

B

Answer to Question 2

A

[javeds]

Thanks for the timely response, appreciate it

[chereeb]

TYSM