This topic contains a solution. Click here to go to the answer
« previous next »

Author Question: Cutting fluids: A) Are coolants and lubricants B) Are used with high-speed steel cutters C) Can ... (Read 99 times)

sdfghj

  • Hero Member
  • *****
  • Posts: 552
on: Jul 26, 2018
Cutting fluids:
 
  A) Are coolants and lubricants B) Are used with high-speed steel cutters
  C) Can be applied as a mist D) All of the above

Question 2

In gang milling, the RPM of the spindle is calculated for cutters with the:
 
  A) Narrowest width B) Greatest width C) Largest diameter D) Smallest diameter


Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

jonathanballen97

  • Sr. Member
  • ****
  • Posts: 347
Reply #1 on: Jul 26, 2018
Answer to Question 1

D

Answer to Question 2

C


sdfghj

  • Hero Member
  • *****
  • Posts: 552
Reply #2 on: Jul 26, 2018
TY


jonathanballen97

  • Sr. Member
  • ****
  • Posts: 347
Reply #3 on: Jul 26, 2018
You're welcome


« previous next »
 

Did you know?

A good example of polar molecules can be understood when trying to make a cake. If water and oil are required, they will not mix together. If you put them into a measuring cup, the oil will rise to the top while the water remains on the bottom.

Did you know?

Adults are resistant to the bacterium that causes Botulism. These bacteria thrive in honey – therefore, honey should never be given to infants since their immune systems are not yet resistant.

Did you know?

The B-complex vitamins and vitamin C are not stored in the body and must be replaced each day.

Did you know?

Less than one of every three adults with high LDL cholesterol has the condition under control. Only 48.1% with the condition are being treated for it.

Did you know?

The average office desk has 400 times more bacteria on it than a toilet.

These adolescents have just graduated and look forward to moving on from high school and adolesence These adolescents have just graduated and look forward to moving on from high school and adolesence
Many exhaust manifolds are constructed of pressed steel and are free flowing to improve engine ... Many exhaust manifolds are constructed of pressed steel and are free flowing to improve engine ...
A typical camshaft-driven high-pressure pump used to increase fuel pressure to 2,000 PSI or higher. A typical camshaft-driven high-pressure pump used to increase fuel pressure to 2,000 PSI or higher.
Graduating High School Graduating High School
Localizing the Source of High-Frequency Sounds Localizing the Source of High-Frequency Sounds
Hot spots highlight areas of high biodiversity Hot spots highlight areas of high biodiversity
Video: Premenstrual Syndrome

For a complete list of videos, visit our video library