Author Question: Slots in workpieces should be measured: A) While they are warm B) Using a micrometer, adjustable ... (Read 82 times)

krzymel

  • Hero Member
  • *****
  • Posts: 548
Slots in workpieces should be measured:
 
  A) While they are warm
  B) Using a micrometer, adjustable parallels or caliper
  C) Before removing them from the vise
  D) Both B and C above

Question 2

The most efficient side milling cutter:
 
  A) Is the the smallest diameter cutter that can be used
  B) Is the largest diameter cutter that can be used
  C) Has teeth only on the periphery
  D) Has teeth on one side only



cpetit11

  • Sr. Member
  • ****
  • Posts: 321
Answer to Question 1

D

Answer to Question 2

A



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
 

Did you know?

Nearly 31 million adults in America have a total cholesterol level that is more than 240 mg per dL.

Did you know?

The Centers for Disease Control and Prevention (CDC) was originally known as the Communicable Disease Center, which was formed to fight malaria. It was originally headquartered in Atlanta, Georgia, since the Southern states faced the worst threat from malaria.

Did you know?

The National Institutes of Health have supported research into acupuncture. This has shown that acupuncture significantly reduced pain associated with osteoarthritis of the knee, when used as a complement to conventional therapies.

Did you know?

Earwax has antimicrobial properties that reduce the viability of bacteria and fungus in the human ear.

Did you know?

According to the CDC, approximately 31.7% of the U.S. population has high low-density lipoprotein (LDL) or "bad cholesterol" levels.

For a complete list of videos, visit our video library