Author Question: The hole size obtained by boring is affected by: A) The material being machined B) The depth of ... (Read 55 times)

WhattoUnderstand

  • Hero Member
  • *****
  • Posts: 517
The hole size obtained by boring is affected by:
 
  A) The material being machined
  B) The depth of cut and the resulting deflection of the boring bar
  C) The size of the boring bar
  D) The RPM of the cutting tool

Question 2

Rigidity in a boring operation is obtained by:
 
  A) Decreasing the feed rate B) Using a short, large diameter boring tools
  C) Increasing the cutting speed D) All of the above



aadams68

  • Sr. Member
  • ****
  • Posts: 317
Answer to Question 1

B

Answer to Question 2

B



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
 

Did you know?

To maintain good kidney function, you should drink at least 3 quarts of water daily. Water dilutes urine and helps prevent concentrations of salts and minerals that can lead to kidney stone formation. Chronic dehydration is a major contributor to the development of kidney stones.

Did you know?

The National Institutes of Health have supported research into acupuncture. This has shown that acupuncture significantly reduced pain associated with osteoarthritis of the knee, when used as a complement to conventional therapies.

Did you know?

The Romans did not use numerals to indicate fractions but instead used words to indicate parts of a whole.

Did you know?

Women are two-thirds more likely than men to develop irritable bowel syndrome. This may be attributable to hormonal changes related to their menstrual cycles.

Did you know?

IgA antibodies protect body surfaces exposed to outside foreign substances. IgG antibodies are found in all body fluids. IgM antibodies are the first type of antibody made in response to an infection. IgE antibody levels are often high in people with allergies. IgD antibodies are found in tissues lining the abdomen and chest.

For a complete list of videos, visit our video library