This topic contains a solution. Click here to go to the answer

Author Question: Table feeds in IPM are found on what type of machine? A) Milling machines B) Lathes C) Grinders ... (Read 153 times)

CORALGRILL2014

  • Hero Member
  • *****
  • Posts: 525
Table feeds in IPM are found on what type of machine?
 
  A) Milling machines B) Lathes C) Grinders D) Drill presses

Question 2

Parallel clamps are mostly used for:
 
  A) Clamping workpieces on the bench for filing and sawing
  B) Clamping workpieces on machines such as drill presses
  C) Holding work for delicate measuring and layout setups
  D) Holding hardened steel precision parallels



Related Topics

Need homework help now?

Ask unlimited questions for free

Ask a Question
Marked as best answer by a Subject Expert

Bigfoot1984

  • Sr. Member
  • ****
  • Posts: 321
Answer to Question 1

A

Answer to Question 2

C



CORALGRILL2014

  • Hero Member
  • *****
  • Posts: 525
Both answers were spot on, thank you once again




 

Did you know?

The horizontal fraction bar was introduced by the Arabs.

Did you know?

Ether was used widely for surgeries but became less popular because of its flammability and its tendency to cause vomiting. In England, it was quickly replaced by chloroform, but this agent caused many deaths and lost popularity.

Did you know?

The largest baby ever born weighed more than 23 pounds but died just 11 hours after his birth in 1879. The largest surviving baby was born in October 2009 in Sumatra, Indonesia, and weighed an astounding 19.2 pounds at birth.

Did you know?

Anti-aging claims should not ever be believed. There is no supplement, medication, or any other substance that has been proven to slow or stop the aging process.

Did you know?

Women are two-thirds more likely than men to develop irritable bowel syndrome. This may be attributable to hormonal changes related to their menstrual cycles.

For a complete list of videos, visit our video library