The MMC condition for a shaft outside diameter would be: A) ...

[chandani]

The MMC condition for a shaft outside diameter would be:
 
  A) The largest diameter allowed by the tolerance B) The rough diameter
  C) A finished diameter D) The smallest diameter allowed by the tolerance

Question 2

A drive center or face driver makes possible the:
 
  A) Facing off the rough end of a shaft or in the case of a drive center, the truing up of the center by a kind of reaming
  B) Driving of a face plate
  C) Driving work between centers so that a cut can be taken full length
  D) Driving of tubular material without chucking it

[enass]

Answer to Question 1

A

Answer to Question 2

C